Filter
Top Products
Page 8 STAR TRAC GROUP CYCLES OWNER’S GUIDE
SPINNER® PRO / ELITE / NXT ASSEMBLY AND SETUP
Use the following procedures to unpack and assemble your STAR TRAC SPINNER ®.
UNPACKING
Prepare the area that you will be unpacking and assembling the bike to be free from debris that may cause damage. Observe all safety precautions and
care while unpacking and assembling the bike. Position the shipping carton so the “Heavy End” logo is located at the bottom. Open the top of the
carton and fold back all four flaps. Carefully tilt the box forward so that the box may be lifted to expose the cycle. Remove all parts from the shipping
carton and foam inserts, and verify that the following parts are included in your shipment:
Assembly Parts (Spinner Pro shown) Spare Parts Kit
NXT Parts List (not shown)
Description Qty. Description Qty.
Main Frame Assembly 1 Rear Leg Assembly 1
Handlebar Post 1 M10x1.5, 55mm Button Head Screw 4
Handlebar w/ Grip & Water Bottle Holders 1 M10x1.5, 65mm Button Head Screw 4
M8x1.25, 16mm Flat Head Screw 2 M10x1.5 Nyloc Hex Nut 8
M8x1.25, 16mm Socket Set Screw 1 10mm Washer, Flat 16
Seat Post 1 Wrench Hex, 5mm 1
Seat Slider Assembly w/ Saddle 1 Wrench Hex, 4mm 1
Pedals (set of two) 1 Multi Wrench 1
Front Leg Assembly w/ Transport Wheels 1
Spare Parts Kit
(includes brake pad and pedal straps) 1
Pro/Elite Parts List (Pro shown above)
Description Qty. Description Qty.
Main Frame Assembly (not shown) 1 F. Water Bottle Cages 2
G. Pop-Pins (pre-installed) 3 Handlebar w/ Grip (& Water Bottle Holders
– Elite only) (not shown)
1
G. M10x1.5, 55mm Flat Head Screw 4
A. Seat Slider Assembly, w/ Saddle 1 G. M10x1.5 Nut 4
B. Seat Post 1 G. 10mm Washer, Flat 4
C. Rear Leg Assembly 1 G. Wrench Hex, 5mm 1
D. Front Leg Assembly w/ Transport Wheels 1 G. Wrench Hex, 4mm 1
E. Pedals (set of two) 1 G. Multi Wrench 1
H. Spare Parts Kit (includes brake pad and pedal
straps)
1
Spare Parts Kit- Save the box of spare parts in a safe place so you have service parts when needed in the future.