Filter
Top Products
Page 12 STAR TRAC GROUP CYCLES OWNER’S GUIDE
5. Install the Handlebar
NXT Only
Positioning the handlebar post with the number 1
on top and insert the handlebar into the handlebar
sleeve locking it at number 4.
Slide the handlebar onto the handlebar post insert
with the water bottle holders facing forward and
align the three screw holes.
Insert the socket head set screw into the handlebar
but do not tighten at this time.
Insert the 2 flat head screws into the handlebar but
do not tighten at this time.
Check for proper alignment then tighten the 2 flat
head screws using a 5mm hex wrench to 60 inch
pounds.
Tighten the set screw to 60 inch pounds using a
4mm hex wrench.
Slide the handlebar post into the frame making sure
the holes face the front of the bike.
Step 5 (NXT)
Allow the post to go into the frame all the way in to
level 1 and align the pop pin so it snaps into the
hole then tighten the pop pin and test for steadiness.
Loosen the pop pin and raise the handlebar to its
highest position number 10 and tighten the pop pin
and test for steadiness.
Pro & Elite Only
Slide the handlebar post into the frame making sure
the holes face the front of the bike.
Allow the post to go into the frame all the way in to
level 1 and align the pop pin so it snaps into the hole
then tighten the pop pin and test for steadiness.
Step 5 (Pro/Elite)
Loosen the pop pin and raise the handlebar to its highest
position and tighten the pop pin and test for steadiness.
6. Install the Bottle Holders (Pro Only)
Using the 3mm Allen Wrench, remove
the two screws from the right side fork
of the frame assembly. Position a
water bottle holder in place against
the frame assembly, and re-install the
two screws to secure.
Repeat to install the cross member
water bottle holder.
Step 6