Filter
Top Products
STEP 1
There is a "R" decal on one end of the FRONT STABILIZER(4), the one with the MOVING WHEELS(48).
Attach the FRONT STABILIZER(4) to the MAIN FRAME(1) with the wheels face to front and the "R" decal
end at right side, then secure with CARRIAGE BOLTS(M8x1.25x60mm)(56), ARC WASHERS(M8)(74),
and ACORN NUTS(M8x1.25)(69).
STEP 2
Attach the REAR STABILIZER(3) onto the REAR FRAME(2) with CARRIAGE BOLTS(M8x1.25x60mm)(56),
ARC WASHERS(M8)(74), and ACORN NUTS(M8x1.25)(69).
NOTE:
R
6
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please call
our toll-free number for assistance 1 (800) 375-7520 or e-mail us at:
parts@staminaproducts.com
ASSEMBLY INSTRUCTIONS
You can adjust the LEVELING CAPS(50) on the REAR STABILIZER(3) to keep the INTONE
Folding Recumbent Bike stable.
Nylock Nut(M8)
Plastic Washer
Fixing Tube
NOTE: Remove the FIXING TUBES, WASHERS, and NUTS from MAIN FRAME(1) and REAR FRAME(2)
before any assembly. These parts are only for packing, do not dispose of the packing materials
until assembly is completed.
STEP 3
Store the PULL PIN(47) by inserting the pin into the hole in the REAR FRAME(2).