Filter
Top Products
STEP 5: Make sure that the threaded holes in the FOOTBAR(5) are facing toward the end of the
AeroPilates
Premier 690 as shown in the illustration. Insert the FOOTBAR(5) into the mounting holes
located in the FRONT COVER(3) and FRONT FRAME(1). Insert the FOOTBAR(5) all the way to the bottom
and lock it in place with the LOCKING KNOBS(26).
NOTE: You can choose to insert the CARDIO REBOUNDER(50) into the FRONT FRAME(1) and lock in
position with the LOCKING KNOBS(26). Refer to the inset drawing.
8
ASSEMBLY INSTRUCTIONS
STEP 6: Insert the PULLEY RISERS(25) into the mounting holes in the REAR COVER(4) and REAR
FRAME(2). Insert the PULLEY RISERS(25) all the way to the bottom, align the threaded holes in the
PULLEY RISERS(25) with the holes in the REAR FRAME(2), and lock the PULLEY RISERS(25) in position
with the LOCKING KNOBS(26).
STEP 4: Remove the paper covering from the foam tape inside the FRONT COVER(3) and REAR COVER(4).
Place the FRONT COVER(3) over the FRONT FRAME(1). Place the REAR COVER(4) over the REAR
FRAME(2). Press the covers securely in place.
STEP 7: Refer to the detail drawing above showing an enlarged view of the left PULLEY RISER(25) and
the LEFT PULLEY HOOK(23). With the pulley facing down, insert the LEFT PULLEY HOOK(23) into the
left PULLEY RISER(25) from the inside as shown. Swing the pulley forward as shown and the LEFT PULLEY
HOOK(23) will be in position for use. Use the same procedure to install the RIGHT PULLEY HOOK(24) on
the right PULLEY RISER(25).