Filter
Top Products
ASSEMBLY INSTRUCTIONS
STEP 2
Remove the paper covering from the foam tape inside the FRONT COVER(7) and REAR COVER(8).
Place the FRONT COVER(7) over the FRONT FRAME(1). Press the FRONT COVER(7) securely in
place. Place the
REAR COVER(8) over the REAR FRAME(2). Press the REAR COVER(8) securely
in place.
NOTE:
The securing
SCREWS(M6 x 35mm)(37) for the PULLEY ASSEMBLY(22) on each side may
need to be loosened to allow the
REAR COVER(8) to fit securely over the frame. Refer to
illustration. When retightening the screws for the
PULLEY ASSEMBLY(22) do not over tighten.
The
PULLEY ASSEMBLY(22) should move freely.
STEP 3
Insert the FOOT REST(9) into the mounting holes located on the FRONT FRAME(1). The FOOT
REST(9) should pass through the FRONT COVER(7) and the FRONT FRAME(1).
STEP 4
Insert the FOAM PAD ASSEMBLIES(17) into the holes located on the CUSHION ASSEMBLY(10).
6