Filter
Top Products
ASSEMBLY INSTRUCTIONS
10
(53) Front Stand
( Wider )
(55) Rear Stand
( Narrower )
Slots
STEP 9
Insert the FOAM PAD ASSEMBLIES(16) into the holes located on the CARRIAGE(7). Place the HAND
STRAPS(20) onto the FOAM PAD ASSEMBLIES(16) for storage.
STEP 10
Refer to the inset drawing. To prevent the CARRIAGE(7) from moving while placing the AeroPilates
Premier Studio onto its stand, attach one of the TENSION CORDS(10) in the slot on the FRONT FRAME(1).
Place the AeroPilates
Premier Studio onto the stand as shown in the illustration.
NOTE: The rubber feet of the AeroPilates
Premier Studio must t into the FRONT STAND(53) and
the REAR STAND(55). The FRONT STAND(53) is wider than the REAR STAND(55). The footbar
end of your AeroPilates
Premier Studio will t into the top of the FRONT STAND(53) and the
headrest end of your AeroPilates
Premier Studio will t into the REAR STAND(55).