Filter
Top Products
SET UP INSTRUCTIONS
10
Equipment Mat
Adjust the LEVELING CAPS(44) on the REAR STABILIZER(3) so that the INSTRIDE
ELLIPTICAL sets on the floor without rocking.
Grasp the HANDRAIL(7) and REAR STABILIZER(3) to move the INSTRIDE
ELLIPTICAL,
two people are required for moving. Do not use the Pedal Arms to move the INSTRIDE
ELLIPTICAL. The Pedal Arms will move and may pinch your hand or fingers.
LEVELING:
MOVING:
Locate and read the WARNING LABEL(69) on the INSTRIDE
ELLIPTICAL. Make sure that
all users read the WARNING LABEL(69).
CAUTION:
FUNCTION INSPECTION:
Visually inspect the INSTRIDE ELLIPTICAL to verify that assembly is as shown in the above illustration.
Check the function of the INSTRIDE ELLIPTICAL. Stand on the foot pedals and place your hands at a
comfortable position on the handrail. Slowly move your highest foot forward and follow the natural path of
the machine. Turn the crank slowly through one complete revolution to verify that the drive train functions
properly. Adjust the TENSION KNOB(22) and verify that it functions properly.
Place the INSTRIDE
ELLIPTICAL in the area where it will be used. It is recommended that the INSTRIDE
ELLIPTICAL be placed on an equipment mat. The INSTRIDE ELLIPTICAL is approximately 33 1/2" long
x 17 3/4" wide x 46 3/4" tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 5.5 feet long
is required for safe operation of the INSTRIDE
ELLIPTICAL. Make sure that adequate space is available
for access to and passage around the INSTRIDE
ELLIPTICAL.