Filter
Top Products
Troubleshooting
22
Electronic self-diagnostic system
When the bicycle is functioning normally, the red LED that is
situated by the controller is lit continually.
In the case of an electronic malfunction, the controller comes
programmed with diagnostic capabilities to determine where the
fault lies. The red LED will emit a series of blinks, count them and
refer to the table below for its explanation and solutions.
No. of
blinks
Explanation Solution
2 Brake lever cut off in
contact
check brake lever spring, brake levers should
return to position (applicable with electric cut-off
levers)
3 Brake lever cut off in
contact
check wiring connection, inspect for damage to
the battery level gauge
4 Throttle not in position check if throttle spring is faulty
5 Throttle failure check throttle connections or replace
6 low voltage recharge battery or loose battery cable
connection
7 excessively high voltage measure battery voltage, contact your eZee
dealer
8 sensor fault contact your eZee dealer
9 motor incompatibility contact your eZee dealer
10 overheat, thermostat
activated
allow to cool, reboot system
11 thermostat failure replace controller
12 amps control / controller
failure
replace controller
No light Power failure check battery, power cables or replace controller