Sportline DUO 1010 Heart Rate Monitor User Manual


 
14
Duo 1010 Dual-Use Heart Rate Monitor
SETTING THE WATCH FUNCTIONS
SETTING HEART RATE TARGET ZONES (continued)
The monitor automatically calculates your Maximum Heart Rate from your User
Profile and uses this information to display Heart Rate Zones.
NOTE: This information must be programmed prior to selecting Target Zone. See page 12.
1. In Heart Rate/Chronograph mode, PRESS & HOLD the MODE key to enter the
Programming Sequence.
2. Select Target Zone (Health, Fat-B=Fat Burn, AROBIC=Aerobic, USR=User
Defined) by PRESSING the START/STOP (S/S) or RESET (R) key. Set Target Zone by
PRESSING the MODE key.
3. Select Zone Alarms ON or OFF by PRESSING the S/S or R key. Set Zone Alarms
by PRESSING the MODE key.
NOTE: Zone Alarm is an audible signal that sounds when you are above or below your selected
Target Heart Rate Zone.
4. Adjust Target Zone Lower Limit (ZONE-L in display) by PRESSING S/S or R key.
Set by PRESSING the MODE key.
5. Adjust Target Zone Upper Limit (ZONE-U in display) by PRESSING S/S or R key.
Set by PRESSING the MODE key.
NOTE: While the watch allows you to manually adjust Zone Limits, it is recommended to leave
them on factory defaults unless consulted by a certified trainer or physician.
6. Select Activity Level (ACt in display) (estimated personal activity level – high=
very active, etc.) by PRESSING S/S or R key. Set by PRESSING the MODE key.
7. PRESS & HOLD the MODE key to exit the Programming Sequence and return to
Heart Rate/Chronograph mode.
ADJUST: S/S or R
SET: MODE