Filter
Top Products
ZE40
5
ASSEMBLY PACK CHECK LIST
M8x20mm Button Head Socket Screw (4pcs)
M8x15mm Hex Head Screw (6pcs)
M8x50mm Button Head Socket Screw (2pcs)
M8x45mm Button Head Socket Screw (4pcs)
M4x30mm Self Tapping Screw (4pcs)
5/16 x 19 x 1.5T Curve Washer (6pcs)
5/16x23x1.5T Flat Washer (8pcs)
M8 Nylon Nut (2pcs)
13/14mm Wrench (1pc)
M5 Allen Wrench (1pc)
Screwdriver(1pc)
Assembly
STEP 1
Install the Front and rear stabilizer into the Frame Base Support with 4pcs of M8x45m/m Hex
Head Screws and 4pcs of 5/16x23x1.5T Flat Washers. Then tightly fasten 4pcs of
M5x38m/m Self Tapping Screws of the Front and rear Stabilizer Cover by using the 13/14mm
Allen Wrench and Screw Driver.
(As shown in Fig.1~7)
STEP 2
Connect the Computer Cable (Upper) with Computer Cable (Lower).
(As shown in Fig. 8)
STEP 3
Install the Front Post into the Main Frame with 6pcs of M8x15m/m Hex Head Screws and
6pcs of5/16x19 x2T Curve Washers by using the 13/14mm Allen Wrench .
(As shown in Fig. 9)
STEP 4
Connect the Computer Cable (Upper) to the 12 pin connector on the back of the console.
Install the Console with 4pcs of M5x15m/m Button Head Socket Screws by using the Screw
Driver.
(As shown in Fig. 10~11)
STEP 5
1. Install the Handle Bar Cover Front onto the Front Post with 1pc of M5x15m/m Button Head
Socket Screws.
(As shown in Fig. 12)
Assembly Instructions