Filter
Top Products
XT200. / XT 600 / XT 800
9
STEP 2
1. Mount the L&R Handle bars onto Handle bar mounting plates at the top of the
upright tubes with 4pcs of 5/16” x 2” Button Head Socket Screw and 4pcs of curved
washer. NOTE: The L&R handle bars are different. The Right handle bar has
two wires and the switches on the handle bar say “Fast and Slow” while the
Left handle bar switch says “Up and Down”.
STEP 3
1. Install the L & R inside console end caps onto the ends of the 1-1/4” X 2-3/8”
console mounting tube. Ensure the end caps are oriented correctly and facing the
correct direction (see diagram). Also ensure that the wiring is fed through the end
caps.
2. Place the console onto the L & R mounting brackets at the top of the upright tubes.
Then install and hand tighten the 2 pcs. of 5/16” x 2-3/4” Hex Head Screw and flat
washers through the hole in the top of the 1-1/4” X 2-3/8” console mounting tube and
the 2 pcs. Of 5/16” x 1-1/2” Button Head Socket Screw and flat washers through the
hole in the front of the 1-1/4” X 2-3/8” console mounting tube.
3. Connect all of the connectors from the console to the mating connectors at the top of
the upright tubes. There should be three connectors on the right side and one
connector on the left side.
4. Install the outside pieces of the console end caps with 6pcs of 3.5mm x 25mm
Phillips head Screw. (Be careful, don’t cut the wires.)
STEP 4
1. Tighten all the screws securely from the previous steps.
2. The mounting screws for the Upright covers are screwed into the base of the
treadmill. You must remove these first. Install the 6pcs of 3.5mm x 25mm Phillips
head Screw into the upright covers.