Filter
Top Products
17
Treadmill
XT685
STEP 1: Press the desired program (Hill, Fat Burn, Cardio, Strength, or
Interval) key. Press Enter to select the program. The display will prompt you
through the programming or you can just press Start to begin the program
with default values.
STEP 2: If Enter was pressed, the Message Center will now be blinking a value,
indicating your Age (default is 35). Entering your correct age affects the heart
rate Bar Graph Display and the Heart Rate programs. Use the + / - keys to
adjust, then press Enter. Your age determines your recommended maximum
heart rate. Since the Bar Graph Display and the Heart Rate features are based
on a percentage of your maximum heart rate, it is important to enter the
correct age for these features to work properly.
STEP 3: The Message Center will now be blinking a value, indicating your Body
Weight (default is 150 lbs.). Entering the correct body weight will affect the
calorie count. Use the + / - keys to adjust, then press Enter. A note about
the Calorie display: No exercise machine can give you an exact calorie count
because there are too many factors which determine exact calorie burn for a
particular person. Even if someone is the exact same body weight, age and
height, their calorie burn may be very different than yours. The Calorie display
is to be used as a reference only to monitor improvement from workout to
workout.
STEP 4: The Message Center will be blinking a value, indicating Time (the default
value is 30 minutes). You may use any of the + / - keys to adjust the time. After
adjusting, or to accept the default, press Enter. (Note: You may press Start at
any time during the programming to start the program).
STEP 5: The Message Center will now be blinking the preset top speed of the
selected program (3 mph or 5 kph). Use the Speed + / - keys to adjust, then
press Enter. Each program has various speed changes throughout; this allows
you to limit the highest speed the program can reach.
STEP 6: The Message Center will be blinking the preset top incline of the
selected program (6.0%). Use the Incline + / - keys to adjust, then press
Enter.
You are now done programming data and may press Start to begin your
workout or Enter to go back one level to change data entered in the
programming phase.
To Select and Start A Preset Program
Programmable Features
The
XT685
offers nine factory preset-programs, two user dened programs and one
Manual program. Each preset program has a maximum speed level that is displayed when a
desired workout is chosen. The maximum speed that the particular program will achieve will be
displayed in the Speed window. Also included are two user programs (User 1 and User 2)
for custom workouts.