Filter
Top Products
XT175 / XT275
7
!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS. PLEASE
READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
Serious injury could occur if this folding treadmill is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill from
unfolding accidentally during shipping. If this strap is not removed properly the treadmill could
spring open unexpectedly and cause injury if someone is standing near the treadmill when the
strap is removed.
To ensure your personal safety during removal of the shipping strap please make sure the
treadmill is positioned flat on the ground, in the orientation it would be in if you were using the
treadmill. Do not turn the treadmill up on its side while removing the shipping strap. This could
cause the treadmills folding mechanism to spring open. If the end of the Velcro strap (that you
need to grab to remove it) happens to be under the treadmill deck, reach under the deck to grab it,
but do not tilt the treadmill up to gain access to the strap end.
Assembly
STEP 1
Remove all parts from the carton.
STEP 2
Connect Lower computer cable with Middle computer cable.
STEP 3
Hand tighten Right and Left uprights into the upright receiving of frame base with eight
5/16x 15m/m Button Head Socket bolts and two 5/16 x 19 x 1.5T Curved Washers by
using the Combination M5 Allen wrench & Phillips head screwdriver.
STEP 4
Connect Middle computer cable with Upper computer cable.
STEP 5
Install the Console Support into the Right and Left uprights with six 5/16 x 15m/m Button
Head Socket bolts and 2pcs of 5/16 x 19 x 1.5T Curved Washers.
Install Upper computer cable into the console.
Install Speed cable and Incline cable into the console.
Install two hand pulse cables into the console.
STEP 6
Slide the Console onto console support plate and attach with six M5 x 15 m/m Phillips
head screws. Note that the console support plate should be inside the console housing
and the mounting screws are installed through the plastic housing and into the mounting
plate.
PLEASE LOCK DOWN ALL HARDWARE AFTER THE ACCESSSORIES HAVE BEEN
ASSEMBLED.
Assembly Instructions (XT175 / XT275)