Filter
Top Products
XU875 & XR895
20
XR895 & XU875 Console
Power on
The XR895 or XU875 Bike has a built-in generator for power and do not need to be plugged into
an AC outlet. To power up the XR895 or XU875 simply start to pedal, the console will turn on
automatically. If the console does not light when you pedal, check that the power switch is set to 0
(Generator). The switch is located on the front, lower left side of the main plastic cover. There is an
optional AC power transformer that is available through your dealer or direct from Spirit. The AC
power transformer would be used if the bike will be operated at very low speeds. In this scenario
the power to the electronic console will be too low to maintain the display. To use the AC power
transformer, plug it into an AC outlet and the power input module of the bike and set the power
switch to 1 (AC power input).
When initially powered on the console will perform an internal self-test. During this time all the
lights will turn on for a short time. When the lights go off the dot matrix display will show a software
version (i.e. VER 1.0) and the message window will display an odometer reading. The odometer
reading displays how many hours the bike has been used and how many virtual miles the bike has
gone. The display shows: ODO 123 MI 123 HRS.
The odometer will remain displayed for only a few seconds then the console will go to the start up
display. The dot matrix display will be scrolling through the different profiles, showing the programs,
and the message window will be scrolling the start up message. You may now begin to use the
console.
Operation of Your Stationary Bike