Filter
Top Products
XE Series Elliptical
16
XE700 Console
Power on
The XE700 has a built-in generator for power and does not need to be plugged into an AC outlet.
To power up the Elliptical simply start to pedal, the console will turn on automatically. If the
console does not light when you pedal, check that the power switch is set to 0 (Generator). The
switch is located on the front, lower left side of the main plastic cover. There is an optional AC
power transformer that is available through your dealer or direct from Spirit. The AC power
transformer would be used if the Elliptical will be operated at very low speeds. In this scenario the
power to the electronic console will be too low to maintain the display. To use the AC power
transformer, plug it into an AC outlet and the power input module of the bike and set the power
switch to 1 (AC power input).
When initially powered on the console will perform an internal self-test. During this time all the
lights will turn on for a short time. When the lights go off the dot matrix display will show a software
version (i.e. VER 1.0) and the message window will display an odometer reading. The odometer
reading displays how many hours the Elliptical has been used and how many virtual miles the
Elliptical has gone. The display shows: ODO 123 MI 123 HRS.
The odometer will remain displayed for only a few seconds then the console will go to the start up
display. The dot matrix display will be scrolling through the different profiles, showing the
programs, and the message window will be scrolling the start up message. You may now begin to
use the console.
Operation of Your Elliptical