Filter
Top Products
XBR25 / XBR55
15
UNPACKING THE UNIT
1. Cut the straps then lift the carton off the bottom tray.
2. Carefully remove all parts from carton and inspect for any damage or missing parts. If damaged
parts are found, or parts are missing, contact your dealer immediately.
3. Locate the hardware package. The hardware is separated into four steps. Remove the tools first.
Remove the hardware for each step as needed to avoid confusion. The numbers in the instructions
that are in parenthesis (#) are the item number from the assembly drawing, for reference.
STEP 1: REAR STABILIZER & SEAT BACK ASSEMBLY
1. Install the Rear Stabilizer (7) onto the Main Frame with the four 3/8 x 2-1/4 Hex Head bolts (65)
and four 3/8 Flat Washers (84) using the 12/14mm Wrench (112).
2. Install Seat Back Frame (5) onto the Seat Carriage (4) with the two 3/8 x 4 Hex Head bolts (67)
and two 3/8 Nylon nuts (89) by using the 12/14mm Wrench (112).
Assembly Instructions (XBR55)