Filter
Top Products
XBR25 / XBR55
18
STEP 4: RELEASE LEVER ASSEMBLY
1. Remove the M6 Button Head Socket Screw holding the clamp of the seat adjustment Release
Lever (40) by using the Allen Wrench (115). Install the Release Lever (40) onto the Handle Bar (6)
just behind the hand pulse sensors. Install the lever at an angle that allows easy access for use,
then install and tighten the socket screw removed earlier.
2. Install the Gas Cylinder (57) into the bracket of the Seat Back Frame (5) with one 5/16 x1-3/4
Hex Head Bolt (70), one 5/16 x 19 x 1.5T Flat Washer (76), 1pc of 5/16x 6T Nylon Nut (91) by
using the 13/14mm Wrench (130) and 13/15mm Wrench (113). Tighten the bolt until snug, but do
not over tighten to the point of binding.
3. Secure the Seat Recline Release Cable (58) and Seat Fore/Aft Release Cables (59) on the
Handle Bar (6) by using the four strips of Velcro Tape.
4. Install the Pedals (116 L, 117 R) in the Cranks by using the 13/15mm Wrench (113). Remember
that the left pedal has a reverse thread and will be screwed into the crank in the opposite rotation
from normal threads. There is an stamped into the end of the threaded post of the left pedal
and an in the right. Make sure to tighten the pedals as much as you possibly can. It may be
necessary to re-tighten the pedals if you feel a thumping during pedaling the bike. A clicking noise,
or thumping, sound during pedaling is usually caused by the pedals being too loose.
5. Install the Upper Computer Cable (44) and Hand pulse Wire Harness (133) into the connector in
the back of the Console (19). Install the console onto the mounting plate with the four M5x12mm
Phillips Head Screws (99) by using the Phillips Head Screw Driver (114).
6. Put on the Beverage Holders (R38&L39) onto left of the Handle Bar Seat (6) with the four 4x16
m/m Self Tapping Screws (105).