Filter
Top Products
Using a Heart Rate Transmitter
The included chest strap is a special high frequency design to minimize outside noise
interference. It is not compatible with other brands of wrist moniters. The on-board radio
receiver is also not compatible with most transmitter chest straps (Polar for example).
How to wear your wireless chest strap transmitter:
1. Attach the transmitter to the elastic strap using the locking parts.
2. Adjust the strap as tightly as possible as long as the strap is not too tight to remain
comfortable.
3. Position the transmitter with the Spirit logo centered in the middle of your body facing
away from your chest (some people must position the transmitter slightly left of
center). Attach the final end of the elastic strap by inserting the round end and,
using the locking parts, secure the transmitter and strap around your chest.
4. Position the transmitter immediately below the pectoral muscles.
5. Sweat is the best conductor to measure very minute heart beat electrical signals.
However, plain water can also be used to pre-wet the electrodes (2 black square areas
on the reverse side of the belt and either side of transmitter). It’s also recommended
that you wear the transmitter strap a few minutes before your work out. Some users,
because of body chemistry, have a more difficult time in achieving a strong, steady
signal at the beginning. After “warming up”, this problem lessens. As noted, wearing
clothing over the transmitter/strap doesn’t effect performance.
6. Your workout must be within range - distance between transmitter/receiver - to
achieve a strong steady signal. The length of range may vary somewhat but generally
stay close enough to the console to maintain good, strong, reliable readings.
Wearing the transmitter immediately against bare skin assures you of proper
operation. If you wish, you may wear the transmitter over a shirt. To do so, moisten
the areas of the shirt that the electrodes will rest upon.
Note: The transmitter is automatically activated when it detects activity from the user’s heart. Additionally, it
automatically deactivates when it does not receive any activity. Although the transmitter is water resistant,
moisture can have the effect of creating false signals, so you should take precautions to completely dry the
transmitter after use to prolong battery life (estimated transmitter battery life is 2500 hours). The replacement
battery is Panasonic CR2032.
Erratic Operation:
Caution! Do not use this treadmill for Heart Rate Control unless a steady, solid
Actual Heart Rate value is being displayed. High, wild, random numbers being
displayed indicate a problem.
If you are receiving erratic radio signals, the large center display will show ERR. You must
correct the cause of interference to continue.
Areas to look for on interference:
(1) Treadmill not properly grounded - A must!
(2) Microwave ovens, T.V.’s, small appliances, etc.
(3) Fluorescent lights.
(4) Some household security systems.
(5) Perimeter fence for a pet.
(6) Loose treadmill console / upright.
10
IN300T /400T
09/24/04