Filter
Top Products
ET2 / ET4
10
Getting familiar with the control panel
ET2 Console
GETTING STARTED:
Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the power switch
located at the front of the treadmill below the motor hood. Ensure that the safety key is installed,
as the treadmill will not operate without it.
When the power is initially turned on, the display will light up and show ODO in the center of the
display and a number in the Distance window. This is an odometer reading that shows how many
virtual miles the treadmill gone. Then HRS is displayed and a number in the Time window shows
how many hours the treadmill has been used. Then VER is displayed and a number in the Speed
window shows the current software version of the console. The console will now be in idle mode,
which is the starting point for operation.
Operation of Your Treadmill