Filter
Top Products
14
15
* TT length is the Horizontal Measurement from the center-line of the HT at the top of the HT to the center-line of the projected seat tube.
** Stand Over height is measured vertically at the centerpoint of the TT measurement.
*Top Tube Length
**Standover Hgt
Head Tube Length
Head Tube Angle (Steep)
Head Tube Angle (Slack)
Seat Tube Angle (Steep)
Seat Tube Angle (Slack)
BB Height (High)
BB Height (Low)
Chainstay Length
Short (mm)
551
711
100
69º
68º
67.5º
66.5º
318
307
424
Short (in)
21.7”
28.0”
3.94”
69º
68º
67.5º
66.5º
12.5”
12.1”
16.7”
Long (mm)
584
711
110
69º
68º
67.5º
66.5º
318
307
424
Long (in)
23.0”
28.0”
4.33”
69º
68º
67.5º
66.5º
12.5”
12.1”
16.7”
1
2
3
4
4
5
5
6
6
7
Headset: 1 1/8”
Seatpost diameter: 30.9mm
Front derailleur clamp: 34.9mm
Rear hub spacing: 135mm
BB shell: 68mm
Seat Collar: 34.9mm
Stroke (Short travel): 31.75mm (1.25”)*
Travel (Short): 3.5”
Stroke (Medium travel): 38.1mm (1.5”)*
Travel (Medium): 4.0”
Stroke (Long travel): 44.45mm (1.75”)*
Travel (Long): 4.5”
Eye-To-Eye: 171.5mm (6.75”)
SIZE SPRING RATE
Short 650lb spring
Long 750lb spring
ENDURO SX FRAME SPECIFICATIONS
NOTE: Using travel chips limits the stroke and travel of the shock. A shorter stroke/travel
requires a stiffer spring to compensate so that the shock doesn’t bottom out. The Enduro SX
comes stock with 2 travel chips, which provides 3.5” travel.
NOTE: Spring weights listed above are to be used as an adjustment starting point only. Rider
weight and riding style may require a different spring rate than the stock spring rate. Replace
the spring accordingly. Refer to your shock manufacturer’s manual for additional shock setup
information.
2 travel chips: Stock spring.
1 travel chip: Stock spring, or test with 50lb lighter spring if exceeding spring preload range.
0 travel chips: Test with 50 lb lighter spring.
* Stroke can be changed by adding or removing “Travel Chips”