Spalding M682001 Fitness Equipment User Manual


 
12/06 ID# M682001
23
Using a portable drill (with adjustable torque) and a
5/16 socket and extension drill through the
backboard frame and secure the pads in place with
self-tapping screws provided. Use screws (7) for
center pad and screws (4) for outer pads
It may be necessary to use an 11/16 drill bit (6) to
pre-drill on some backboards (FIG. A).
A center punch is recommended to mark hole
locations prior to drilling to keep drill bit from
wandering.
If the ends of the screws are exposed after
installation, place the screw protectors (5) over the
ends to prevent injury.
BOARD PAD - INSTALLATION
1.
Check the fit of the edge guards and reposition
slightly if necessary. It may be necessary to trim
away some material to fit it around the goal or
supports. NOTE: CHECK FASTENER LOCATIONS
TO MAKE SURE THEY WILL NOT DAMAGE THE
BACKBOARD GLASS.
1
2
7
4
4
3
5
4
4 or 7
FIG. A.
6
The enclosed Molded Edge Guards interlock together to form bottom and side protection for
one backboard with an overall width of 54".
3.
2.
Collect any metal shavings that may have fallen
onto the floor or driveway to prevent injury.