Filter
Top Products
FX4 MOTORIZED TREADMILL
Visit us at: www.evofitness.com
22
STABILIZER ADJUSTMENT
STABILIZER ADJUSTMENT:
An uneven floor or improper stabilizer level can cause the treadmill to wobble during use as well as the incline adjustment to
function incorrectly. Please follow the procedure described below to make sure the treadmill stabilizer is adjusted correctly
prior to use. You may need the assistance of another person to perform this adjustment.
1. To perform the stabilizer adjustment you first need to bring the treadmill to the highest incline level as shown in FIG1.
After you’ve completed the assembly procedure plug in the power cord and switch on the POWER SWITCH. Insert the
Safety Key and press the START button to quick start the treadmill. Press the INCLINE UP button until Level 12 shows on
the console. This is the highest incline level. Now press the STOP button and pull out the Safety Key. Switch off the
POWER SWITCH and unplug the power cord.
2. Inspect the four stabilizers (two per side) located underneath the base frame. The treadmill should sit on the floor with all
4 stabilizers resting firmly on the floor as shown in FIG2. Shake the handlebars back and forth to check if they are resting
firmly on the floor. If they are not, pull the handlebar backward to adjust the two front stabilizers and push the handlebar
forward to adjust the two rear stabilizers as shown in FIG3. Simply turn the stabilizers like a screw to adjust their heights.
Repeat this until all 4 stabilizers sit firmly on the floor.