Filter
Top Products
SMOOTH 7.1HR POWER FOLDING TREADMILL
Visit us at: www.smoothfitness.com
28
TROUBLESHOOTING
Troubleshooting
NOTE: Do not touch any internal electric wires without consulting the manufacturer.
No display on the Computer LCD, after the power is switched on:
1. Make sure the power cord has been plugged in properly to the power switch on the base frame and mains power socket.
2. Make sure the safety key is inserted properly into the safety key slot on the console. Try pulling it in and out several times
until the LCD lights up.
Computer LCD lights up but the running belt has no movement:
1. Follow the console operating instructions for the P1 manual program then press the Start button to see if the belt will move.
The belt should move at 0.5 mph.
2. If the belt still does not move, press the Speed Up button and see if the speed LCD window indicates the speed increasing.
3. If when you press the speed button the speed LCD window indicates the speed increasing, but the belt still does not move
please contact the manufacturer help.
Treadmill will not fold up:
1. If the incline level is above level 1, press the Reset button on the computer. The treadmill incline level should return to
level 1 and stop. Then please follow the Power Fold Instructions in this manual to complete the fold up operation.
2. If the incline has been lowered to level 1, but you cannot lock the spring load knob, please turn the spring load knob
clockwise. Then lift the treadmill frame from the rear end slightly and check if the spring load knob can be locked in. If you
can lock in the spring load knob, then your treadmill is not on a level surface. Please check if both rear wheels are sitting on
the floor evenly, or follow the Level Adjustment Instructions in this manual to adjust the level adjusters underneath the base
frame until both rear wheels sit evenly on the floor and the spring knob can be locked in.
Computer LCD does not show the pulse:
1. First, please press the Start button to start the treadmill. Place both hands on the heat rate contact sensors on the
handlebars. Then check if the LCD shows a blinking heart symbol. If the blinking heart symbol is displayed then the
computer is sensoring your pulse properly. Keep your hands on the sensors until the actual pulse number is displayed on the
LCD.
2. If when holding the contact sensors on the handlebars the heart symbol is not displayed, please disassemble the
handlebars and check to make sure both sensor wires are assembled correctly. Disconnect and then reconnect them again.
Then try the heart rate contacts again.
Treadmill will not start:
1. Make sure the power cord is plugged into a surge protector, the surge protector is plugged into a properly grounded outlet
and the surge protector is turned on (refer to the Power Requirements section in this manual).
2. Check the circuit breaker reset switch located on the front of the treadmill. Turn the power off, wait 5 minutes then press
the rest switch.
3. Check the house electrical breaker box and the circuit breaker for the room the treadmill is located in. If it has tripped,
reset or have an electrician replace the breaker in home.
4. Have an electrician check for inadequate voltage at the outlet.