Filter
Top Products
3
OPERATIONAL SUMMARY
While looking through the monocular, depress the power button once to activate the inview display system (LCD). Aim the SIMMONS LASER
RANGEFINDER at a target at least 5 yards away, depress and hold the power button down until range reading is displayed. Release the power
button. Note: Once activated, the SIMMONS LASER RANGEFINDER’s LCD will remain active and display the last distance measurement for 30
seconds. You can depress the power button again at any time to distance to a new target. As with any laser device, it is not recommended to directly
view the emissions for long periods of time with magnified lenses.
FEATURES
Your SIMMONS LASER RANGEFINDER’s LCD incorporates illuminated indicators that advise you unit of measure, when the laser is active, the battery
charge is low, and when a target has been acquired. A summary of these features is presented below:
UNIT OF MEASURE OPTIONS – The SIMMONS LASER RANGEFINDER can be used to measure distances in yards. The unit of measure indicator is
located in the lower right portion of the LCD.
ILLUMINATING INDICATORS – Low Battery Charge ( ) When the low battery symbol is displayed in the upper right-hand portion of the LCD,
the battery charge is getting low and the 9-volt alkaline battery should be replaced.
Target Acquired: Informs the user that a distance measurement has been obtained. The message “TARGET ACQUIRED” will appear in the top portion
of the LCD. The distance measured will appear at the bottom of the LCD in numerical form.