Filter
Top Products
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove the packing matedals. Do not dis-
pose of the packing matedals until assembly is completed. Assembly requires the Included allen wrench |,a
phillips screwdriver _====(Z_), two adjustable wrenches _ and scissors
L__
(not Included).
. Refer to the drawing on page 4 and Identify the right
slde of the treadmill. With the help of a second person,
carefully lay the treadmill on its dght side; do not lay the
treadmill on its left side or the storage latch may be
damaged.
Firmlyslide a Base Extension (76) into one side ofthe
Base (86). Using the Allen Wrench (89), tighten an
Extension Bolt (13) into the Base Extension and the
Base. While the treadmill ison its side, attachthe other
Base Extension (not shown) in the same manner.
76
86
e
Attach six Base Pads (43) to the Base (86) and the Base
Extensions (76) in the indicated locations. Note: An extra
Base Pad may be included.
With the help of a second person, carefully raise the
treadmill to the updght position so the Base (86) and the
Base Extensions (76) are resting on the floor.
Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow the instructions to lower the treadmill.
2
86
3. Cut the two Shipping Ties from the Handrails (61).
3
Shipping
.
Remove the four Handrail Bracket Screws (128) from the
dght side of the Frame (83). Position the right Handrail
Bracket (42) over the four screw holes in the Frame.
Loosely thread two of the Screws intothe back holes of
the Bracket and into the Frame as shown.
Repeat this step on the left side of the Frame (83).
5