Filter
Top Products
6
7
45
45
58
58
2
21
49
10
7
11
17
5
5
6
51
56
36
Hole
1
4
51
5. Push the Magnet Bracket (36) into the hole in the
Pedal Frame (4).
Lubricate an Frame Axle (13). Attach the Pedal
Frame (4) to the Main Frame (1) with the Frame
Axle (13), two Rubber Washers (51), and two Axle
Fasteners (56).
6. Attach the Left Side Shield (21) to the Seat Frame
(2) using three Fastener Bases (45) and three
Fastener Pins (58). First, insert the Fastener Bases
through the Side Shield and into the Seat Frame.
Next, push the Fastener Pin (58) into the hole in
each Fastener Base until it is flush with the Base.
Attach the Right Side Shield (22, not shown) in the
same way.
7. While another person holds the Long Link Arm (10)
and the Short Link Arm (11) in place, put two Plastic
Washers (49) between them. Then, connect the
Seat Swing Arm (5), the Long Link Arm (10), and
the Short Link Arm (11) using an M8 x 1.375” Bolt
(17) and an M8 Nylon Jam Nut (7).
8. Place the Seat (20) on the Frame (2). Slide the
Seat Washer (38) onto the Seat Knob Bolt (43) and
then tighten the Seat Knob (37) onto it.
Slide the Weight Bracket (8) onto the Seat Frame
(2) so that it slants away from the AEROBIC RIDER
2. Align the holes in the Weight Bracket with the
ones in the end of the Frame. Insert the M8 x
120mm Bolt through the Weight Bracket and the
Frame and secure it with an M8 Nylon Jam Nut (7).
8
2
20
43
38
57
7
37
8
Lubricate—13
56