Schwinn 140 Exercise Bike User Manual


 
Foot Position / Pedal Strap Adjustment
Foot pedals with straps provide secure footing to the exercise bike.
1. Put the ball of each foot on the Pedals.
2. Rotate the Pedals until one can be reached.
3. Fasten the strap over the shoe.
4. Repeat for the other foot.
Be sure toes and knees point directly forward to ensure maximum Pedal efficiency. Pedal
straps can be left in position for subsequent workouts.
Adjust Console
To adjust the console tilt position:
1. Loosen the knob below the console.
2. Carefully move the console tilt to one of the available positions.
3. Tighten the knob.
Power-Up Mode
The Console will enter POWER-UP mode if it is plugged into a power source, any button is pushed, or if it receives an indication
from the RPM sensor as a result of pedaling the machine.
Auto Shut-Off (Sleep Mode)
If the Console does not receive any input in approximately 5 minutes, it will automatically shut off. The LCD display is off while in
Sleep Mode.
Note:
The Console does not have an On/Off switch.
Quick Start / Manual Program
The Quick Start / Manual program lets you start a workout without entering any information.
1. Step on the machine.
2. Push the QUICK START button to start the QUICK START / MANUAL program.
3. Push the Increase or Decrease buttons to change the resistance level. The default Quick Start resistance
level is 3. The time will count up from 00:00.
4. Push STOP when done with your workout.
Workout Program Selection
To go to the Program Menu, you must first make a User selection in the User menu. Use the Increase/Decrease buttons to look at
1212
12
Note: Different models can have the knob on the top or the side of the seat bracket.