Filter
Top Products
1. Hold down the LOCK/SCAN button and Increase button together for 3 seconds while in the POWER-UP
MODE to go into the CONSOLE SETUP MODE.
2. Push the Increase/Decrease buttons to change between ELLIPTICAL and BIKE.
3. Push START/ENTER to set.
4. Push the Increase/Decrease buttons to change between ENGLISH and METRIC units.
5. Push START/ENTER to set.
6. Push Increase/Decrease to adjust the screen contrast (BACKLIGHTS; “5” = maximum intensity, “1” =
minimum).
7. Push START/ENTER to set.
8. The Console shows TOTAL HOURS.
9. Push START/ENTER.
10. Push Increase/Decrease to turn motivational messages off or on.
11. Push START/ENTER to set.
12. Push Increase/Decrease to set which software version to use (“SW30 V1.0” = x20 machine, “SW40
V1.0” = x40 machine, or “NLS 514” = 514 machine).
13. Push START/ENTER to set.
Note:
Push STOP/RESET for previous screen.
Auto Shut-Off (Sleep Mode)
If the Console does not receive any input in approximately 5 minutes, it will automatically shut off. The LCD display is off while in
Sleep Mode.
Note:
The Console does not have an On/Off switch.
1212
12