Filter
Top Products
9
HOW TO INSTALL THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
The elliptical exerciser is now fully assembled. If you purchase the optional chest pulse sensor (see
page 21), follow the steps below to install the receiver included with the chest pulse sensor.
1. See assembly step 7 on page 7, and remove the two
M4 x 25mm Screws (not shown) and the Bookrack (7).
Next, look under the Console (8) and locate the three
indicated screws (not shown). Remove the three
screws. Do not remove the screws attaching the
Console to the Console Bracket (not shown).
2. Carefully lift the top of the Console (8) as shown. Using
the two small screws included with the chest pulse sen-
sor, attach the receiver to the indicated plastic posts on
the Console. Make sure that the receiver is turned
exactly as shown. Connect the wire on the receiver to
the indicated wire on the Console.
See step 1 above. Lower the top of the Console (8).
Make sure that no wires are pinched. Reattach the
top of the Console with the three screws removed in
step 1. See assembly step 7 on page 7, and reattach
the Bookrack (7) with the two M4 x 25mm Screws (not
shown). Note: The remaining wires included with the
chest pulse sensor may be discarded.
Posts
W
ire
7
8
8
1
Receiver
2
Screws
13. Make sure that all parts are properly tightened before you use the elliptical exerciser. Note: Some
hardware may be left over after assembly is completed.
12. Set the Left Pedal Arm (33) on the left Pedal Cushion
(74), and hold the end of the Left Pedal Arm inside of
t
he bracket on the Left Pedal Leg (28).
H
old a Plastic Pedal Arm Spacer (65) between the
Left Pedal Leg (28) and the Left Pedal Arm (33).
Insert the long part of a Bolt Set (67) through the Left
Pedal Leg, the Plastic Pedal Arm Spacer, and the
Left Pedal Arm.
Apply a film of the included grease to the long part of
the Bolt Set (67). Lift the Left Pedal Leg (28), and
hold the lower end of the Left Upper Body Arm (5)
inside of the bracket on the Left Pedal Arm (33).
Insert the long part of the Bolt Set through the Left
Upper Body Arm. Hold another Plastic Pedal Arm
Spacer (65) between the Left Pedal Arm and the Left
Pedal Leg, and insert the long part of the Bolt Set
through these parts. Tighten the short part of the Bolt
Set into the long part.
Attach the Right Pedal Arm (32) in the same way.
65
65
33
32
28
67
67
74
5
Grease
12
Screws