Filter
Top Products
6. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 20). To protect the floor or carpet
from damage, place a mat under the treadmill.
7
4. Slide the upper end of a Handrail (85) and then the
Extension Leg (103) into the right Upright (82) as shown.
Note: It may be helpful to tip the Uprights forward as you
insert the Extension Leg. If necessary, tap the Extension
Leg with a rubber mallet to fully insert it.
Slide the other Handrail (85) and Extension Leg (not
shown) into the left Upright (82) as described above.
82
85
85
82
103
4
5
101
78
101
82
78
103
103
82
97
85
85
97
116
116
97
5. With the help of a second person, carefully tip the Uprights
(82) down as shown. Make sure that the Extension
Legs (103) and Handrails (85) remain in the Uprights.
Attach each Extension Leg (103) with two Screws (101)
and a Base Pad (116) as shown. Make sure that the
Extension Legs are fully inserted into the Uprights (82).
Push down on the Uprights and push the bottom of the
Extension Legs as you tighten the Screws. Tighten the
Handrail Bolts (78).
Note: One replacement Base Pad (116) and Spacer (not
shown) are included. If a Base Pad becomes worn and
needs to be replaced, use the replacement Base Pad. If
a Thick Base Pad (97) needs to be replaced, use the re-
placement Base Pad with the Spacer.
With the help of a second person, carefully tip the
Uprights (82) back to the upright position.