Filter
Top Products
30
PROBLEM: The displays and indicators on the console remain lit after the key is removed
SOLUTION: a. Hold down the STOP button while inserting the key into the console.
Make sure that there is not a letter ÒdÓ in the CALS/FAT CALS
display. If a ÒdÓ appears in the display, the console is in the ÒdemoÓ
mode. This mode is intended to be used only when a treadmill is dis-
played in a store. When the console is in the demo mode, the power
cord can be plugged in, the key can be removed from the console,
and the displays and indicators on the console will automatically light
in a preset sequence, although the buttons on the console will not operate. If a ÒdÓ appears in the
CALS/FAT CALS display, press the SPEED Ð button so the display is blank. Then, remove
the key from the console.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and unplug the
power cord. Next, remove the two Short Hood
Screws (133) from the Motor Hood (62). Pivot the
Uprights (39) in the direction shown by the arrow until
the handles are resting on the floor. Note: It will be
easier and safer if two people perform this opera-
tion.
Locate the two Screws (41) in the space between the
front edge of the Motor Hood (62) and the treadmill.
Remove the Screws.
Return the Uprights (39) to the vertical position. Lift off the Motor Hood (62), being careful not to
damage the hook and loop fasteners on the front of the belly pan.
Locate the Reed Switch (59) and the Magnet (134) on
the left side of the Pulley (8). Turn the Pulley until the
Magnet is aligned with the Reed Switch. Make sure
that the gap between the Magnet and the Reed
Switch is about 1/8Ó. If necessary, loosen the Screw
(64) and move the Reed Switch slightly. Retighten the
Screw.
Re-attach the Motor Hood (62) and run the treadmill
for a few minutes to check for a correct speed reading.
134
8
Top
View
1/8Ó
59
64
133
41
62
39
133