Filter
Top Products
4. Raise the treadmill to the storage position (see HOW TO
FOLD THE TREADMILL FOR STORAGE on page 24).
Have a second person hold the treadmill in the upright posi-
tion. Position the U-base (20) against the base of the
Uprights (65) as shown, with the Bumpers (98) under the
U-base. Finger tighten two 2” Bolts (26) with Base
Washers (129) into the base of the Uprights and the U-
base. Then, attach the U-base with two 3” Bolts (23), two
Base Washers (129), and two Nuts (13). Tip the treadmill
forward if necessary. Tighten the two 2” Bolts.
5.
Make sure that all parts are properly tightened before
you use the treadmill. Place a mat beneath the tread-
mill to protect the floor. For your benefit, familiarize your-
self with the information on pages 25 and 26.
13
23
20
98
98
65
4
13
26
55
69
5
70
3
72
68
62
10
Hole
3. (Note: The parts shown in this step may be preassembled
but may need to be adjusted.) With the help of a second
person, raise the Frame (55) and hold it. Insert the Left
Frame Guide (68) into the left side of the Frame. Remove
the Latch Knob (67) from the Latch Pin (72). Make sure
that the Latch Pin Collar (70) and the Spring (69) are on
the Latch Pin. Insert the Latch Pin into the Frame and the
Left Frame Guide. Press the Latch Insert (5) onto the
Frame, with the Latch Pin in the center hole. Tighten the
Latch Knob onto the Latch Pin.
Align the Latch Pin (72) with the hole in the Left Foam
Grip (62) by sliding the Left Frame Guide (68) up or down.
Make sure that the Latch Pin can be inserted fully into the
hole. Hold the Left Frame Guide in place and tighten two
1/2” Screws (10) into the Latch Insert and the Left Frame
Guide. Note: It may be necessary to pull the Latch Knob
(67) to access and tighten the Screws.
67
129
23
7
PART IDENTIFICATION CHART
Use
the chart below to identify small parts needed for assembly.
Nut (13)–2
3/4” Screw (101)–4
Base Washer (129)–4
Screw (40)–8
Plastic Fastener
(75)–4
2” Bolt (26)–2
3” Bolt (23)–2
26
129