Filter
Top Products
8
68
5
Collar
Spring
114
55
Knob
132
3
Small
Holes
3. With the help of a second person, raise the treadmill
F
rame (55). Hold the Latch Housing (68) and the Latch
Housing Cover (5) against the sides of the Frame as
shown. Loosely thread the two blunt-tipped 1/2” Screws
(132) into the Latch Housing Cover and the Latch Housing
as shown. Do not tighten the Screws yet.
Remove the knob from the pin. Make sure that the collar
a
nd the spring are on the pin. The collar should be on the
side of the spring shown. Insert the pin into the Latch
Housing (68), and tighten the knob back onto it.
Align the pin with the hole in the Left Handgrip (140) by
sliding the Latch Housing (68) up or down. Make sure that
the pin can be inserted fully into the hole. Hold the Latch
Housing in place as you tighten two 1/2” Tek Screws (114)
into the Latch Housing and the Frame (55). Then, tighten
the 1/2” Screws (132). Note: It may be necessary to pull
on the knob to access and tighten the Screws.
5. Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the
treadmill to protect the floor or carpet. Note: Extra hardware may be included. Keep the included allen
wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 23). For your benefit,
we recommend that you familiarize yourself with the TROUBLESHOOTING section on pages 23 and 24.
Hole
Pin
140
114
132
4. Note the location of the 75 ohm antenna terminal on
the treadmill. For the television to operate properly, an
antenna, a CATV cable, or a VCR must be connected
to the 75 ohm antenna terminal.
If you are using an antenna, it must be properly con-
nected and adjusted for optimal reception. See ANTENNA
CONNECTIONS on page 9 to properly connect an an-
tenna. If you are using a CATV cable, see CATV CABLE
CONNECTION on page 9 to properly connect the cable. If
you are using a VCR, see HOW TO CONNECT A VCR
on page 9 to properly connect the VCR. The VCR must
be turned on, a videocassette must be properly in-
serted, and the VCR must be playing. See your VCR
user’s manual for operating instructions.
4
75 Ohm Antenna Terminal