Filter
Top Products
11
Inspect and tighten all parts of the exercise cycle reg-
ularly. The exercise cycle can be cleaned with a soft,
damp cloth. To prevent damage to the console, keep
liquids away from the console and keep the console
out of direct sunlight.
Inspect and prop-
erly tighten all
parts of the exer-
cise cycle regular-
ly. Make sure to
keep the indicated
screws tight (there
are two screws on
each side). In
addition, make
sure to keep the
pedals tightened.
HOW TO LEVEL THE EXERCISE CYCLE
If the exercise
cycle does not sit
flat on the floor,
turn one or both of
the leveling pads
until the exercise
cycle is level.
PULSE SENSOR TROUBLESHOOTING
• Avoid moving your hands while using the pulse sen-
sor. Excessive movement may interfere with heart
rate readings.
• If your heart rate is not shown when the pulse sen-
sor is used, press the resistance – button to reset
the display.
• Do not hold the metal contacts too tightly; doing so
may interfere with heart rate readings.
• For the most accurate heart rate reading, hold the
metal contacts for about 15 seconds.
• For optimal performance of the pulse sensor, keep
the metal contacts clean. The contacts can be
cleaned with a soft cloth—never use alcohol,
abrasives, or chemicals.
CONSOLE TROUBLESHOOTING
If the console display flickers while you are changing
the resistance setting, increase your pedaling pace.
HOW TO SELECT MILES OR KILOMETERS
The console can
display speed and
distance in either
miles or kilome-
ters. The letters
“MPH” or “KMH”
will appear in the
display to show
which unit of mea-
surement is
selected. To
change the unit of
measurement, first remove the access door from the
back of the console. Locate the Reset button and the
switch inside the console. Slide the switch up or down
to select miles or kilometers, and then press the
Reset button. Reattach the access door to the back of
the console.
MAINTENANCE AND TROUBLESHOOTING
Leveling
Pads
Keep these
screws tight
Reset
Button
Switch