Filter
Top Products
22
Inspect and properly tighten all parts of the elliptical
e
xerciser regularly. Replace any worn parts immedi-
ately.
For smooth
o
peration of the
elliptical exer-
ciser,
inspect
and clean the
ramp regularly
using a soft
cloth and mild
detergent.
Other parts of
the elliptical
exerciser can
also be cleaned
in this way. Keep liquids off the console. Never use
abrasives or solvents.
PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function proper-
ly, see step 6 on page 12.
HOW TO CALIBRATE THE INCLINE SYSTEM
If the elliptical exerciser’s incline system is not working
properly, activate the calibration process by following
the steps below.
1. Hold down the Start button and the increase but-
ton to the left of it at the same time for about five
seconds. Note: Numbers may appear in the dis-
plays; disregard these numbers.
2.
Press the Programs button. Note: A combination of
letters and numbers will appear in the display.
3. Press the 30° Quick Ramp button. The ramp will
rise to the highest position and then move down to
the lowest position.
4.
Press the Programs button three times. The con-
sole will then be in the normal operating mode and
the elliptical exerciser will be ready for use.
HOW TO MOVE THE ELLIPTICAL EXERCISER
Stand behind the elliptical exerciser and hold the indi-
cated handle firmly. Lift the handle until the elliptical
exerciser can be moved on the front wheels, and
c
arefully move the elliptical exerciser to the desired
location. Then, carefully lower the elliptical exerciser.
Due to the size and weight of the elliptical exercis-
er, use extreme caution while lifting, moving, and
lowering it.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
If the elliptical
exerciser
rocks
during use, turn
one or both of
the leveling feet
under the front
stabilizer until
the rocking
motion is elimi-
nated.
Ramp
Leveling
Foot
Lift Here
Wheel
MAINTENANCE AND TROUBLESHOOTING