Reebok Fitness RBEX59021 Home Gym User Manual


 
8
HOW TO ADJUST THE POSITION OF THE SEAT
For effective exercise, the seat should be in the proper
position. As you pedal, there should be a slight bend
in your knees when the pedals are in the farthest
position. To adjust
the seat, pull the
seat knob and
slide the seat car-
riage to the desired
position. Release
the seat knob and
slide the seat car-
riage back and
forth slightly until
it locks into posi-
tion.
HOW TO ADJUST THE PEDAL STRAPS
To adjust the pedal
straps, first pull the
ends of the straps
off the tabs on the
pedals. Adjust the
straps to the
desired positions
and press the ends
of the straps back
onto the tabs.
Strap
Tab
EXERCISE CYCLE OPERATION
HOW TO INSTALL THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver
included with the chest pulse sensor.
1. Refer to assembly step 4 on page 5, and remove the
two M4 x 25mm Screws (not shown) and the Bookrack
(55).
Next, look under the console and locate the three indi-
cated screws (not shown). Remove the three screws.
Do not remove the screws attaching the Console to
the Handlebar Post (6).
2. Carefully lift the top of the Console (9) as shown. Using
the two small screws included with the chest pulse sen-
sor, attach the receiver to the indicated plastic posts on
the Console. Make sure that the receiver is turned
exactly as shown. Connect the wire on the receiver to
the indicated wire on the Console.
Refer to step 1 above. Lower the top of the Console (9).
Make sure that no wires are pinched. Reattach the
top of the Console with the three screws removed in
step 1. Refer to assembly step 4 on page 5, and reat-
tach the Bookrack (55) with the two M4 x 25mm
Screws (not shown). Note: The remaining wires includ-
ed with the chest pulse sensor may be discarded.
Posts
Wire
55
6
9
9
1
Receiver
2
Screws
Screws
Seat
Carriage
Seat
Knob