Filter
Top Products
7
10. Identify the Left Pedal (22), which is marked with an
“L.” Using an adjustable wrench, firmly tighten the
Left Pedal
counterclockwise
into the Left Crank
Arm (24). Tighten the Right Pedal (not shown)
clock-
wise
into the Right Crank Arm (not shown). Important:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten
the Pedals.
Adjust the Left Pedal Strap (25) to the desired posi-
tion, and press the end of the Left Pedal Strap onto
the tab on the Left Pedal (22). Adjust the Right
Pedal Strap (not shown) in the same way.
10
11. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
9. While another person holds the Seat Bracket (11) near
the Seat Carriage (41), connect the Right Controller
Wire (93), which has a tag attached, to the wire on the
Rear Wire Harness (51), which also has a tag
attached. Then, connect the Left Controller Wire (98)
to the Rear Wire Harness. Make sure the connectors
on the Controller Wires (93, 98) are positioned side
by side under the plastic cover on the Seat
Bracket.
Attach the Seat Bracket (11) to the Seat Carriage (41)
with four M8 x 19mm Button Screws (77) and four M8
Split Washers (55).
22
25
24
11
98
41
51
93
77
77
Plastic
Cover
55
55
9
Avoid pinching and
damaging the wires.