Filter
Top Products
6
4. Attach the Handlebar (7) to the Handlebar Post (6)
with three M8 x 20mm Button Screws (19) and
three M8 Flat Washers (18). Make sure to thread
the Upper Wire Harness (16) and the Pulse
Wires (22) through the indicated hole in the
Handlebar.
5. The Console (9) requires two ÒAAÓ batteries (not
included); alkaline batteries are recommended.
Remove the battery cover from the back of the
Console. Press two batteries into the battery clip as
shown in the inset drawing. Make sure that the
negative (Ð) ends of the batteries are touching
the springs. Reattach the battery cover.
While another person holds the Console (9) near
the Handlebar (7), connect the Pulse Wires (22) to
the console wires. Next, plug the Upper Console
Wire (16) into the socket in the back of the Console.
Insert all excess wiring down into the Handlebar
Post (6). Attach the Console (9) to the Handlebar
(7) with four M4 x 10mm Screws (21).
7
6
Console
Wire
Console
Wire
9
22
16
21
4
5
6. Attach the Seat (12) to the Seat Post (11) with four
M6 x 16mm Hex Screws (29) and four M8 Flat
Washers (18). Note: The Hex Screws and Flat
Washers may be pre-attached to the Seat.
Using an adjustable wrench, remove the Seat Knob
Assembly (31) from the Frame (1).
Insert the Seat Post (11) into the Frame (1). Slide
the Round Collar (13) down the Seat Post and
press it into the Frame. Secure the Round Collar to
the Frame with a M6 x 10mm Screw (26).
Reinstall the Seat Knob Assembly (31) to the Frame
(1).
12
11
13
18
29
26
31
1
6
6
18
19
19
18
16
7
Hole
Batteries
Battery
Clip