Filter
Top Products
7
68
5
Collar
Spring
49
55
Knob
132
Small
Holes
3. With the help of a second person, raise the treadmill
F
rame (55). Hold the Latch Housing (68) and the Latch
Housing Cover (5) against the sides of the Frame as
shown. Loosely thread the two blunt-tipped 1/2” Screws
(132) into the Latch Housing Cover and the Latch Housing
as shown. Do not tighten the Screws yet.
Remove the knob from the pin. Make sure that the collar
a
nd the spring are on the pin. The collar should be on the
side of the spring shown. Insert the pin into the Latch
Housing (68), and tighten the knob back onto it.
Align the pin with the hole in the Left Handgrip (87) by slid-
ing the Latch Housing (68) up or down. Make sure that the
pin can be inserted fully into the hole. Hold the Latch
Housing in place as you tighten two 1/2” Tek Screws (49)
into the Latch Housing and the Frame (55). Then, tighten
the 1/2” Screws (132). Note: It may be necessary to pull
on the knob to access and tighten the Screws.
5. Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the
treadmill to protect the floor or carpet. Keep the included allen wrench in a secure place. The allen wrench
is used to adjust the walking belt (see pages 26 and 27).
Hole
Pin
87
49
132
4. Remove the backing from the indicated tape on the con-
sole assembly. Press the Book Holder (50) firmly onto the
tape. Note: The Book Holder may be preassembled.
Console
Assembly
50
Tape
4
3