Filter
Top Products
5
REPAIR AND MAINTENANCE
1
Use the special valve
extender/adapter supplied.
The valve adap
ter is located
in the bag with the owners
manual supplied at the time
of purchase.
2
Align the access hole in
the drive sprocket with the
tire valve. Thread the adapter
completely onto the valve and
attach the pump. Infl ate to
the PSI indicated on the tire
sidewall.
3
Remove valve adapter
immediately after infl ating.
❑
Infl ating the Tires
Tires are infl ated when shipped, but they invariably lose some pressure between the point of
manufacturing and
your purchase.
E200/E300 Rear Tire
1
Using a bicycle style tire
pump equipped for a Schrader-
type valve, infl ate the front
tire to the PSI indicated on the
sidewall of the tire.
E200/E300 F
ront Tire and E100 Tires
WARNING:
Failure
to remove the valve adapter
after infl ating will cause the
inner tube and/or adapter to
be severed by the rear drive
sprocket.
Note:
If you lose the adapter,
a valve stem extender can be
purchased at almost any auto
parts store.
Note:
The pressurized air
supplies found at gasoline
stations are designed to infl ate
high-volume automobile tires.
If you decide to use such an air
supply to infl ate your electric
scooter tires, fi rst make sure
the pressure gauge is working,
then use very short bursts to
infl ate to the correct PSI. If you
inadvertently over-infl ate the
tire, release the excess pressure
immediately.
E_Series_Manualv10.indd 6 3/10/06 2:10:59 PM