Filter
Top Products
8
7.
Tighten the four Handrail Bolts (37) with the four
1/4” Star Washers (95) into the Uprights (69) and
the Handrails (71). Start all four Handrail Bolts
before tightening any of them.
95
37
95
37
71
71
95
69
69
37
7
5. Set the Console (43) face-down on a soft sur-
face to avoid scratching the Console. Next, set
o
ne of the Handrails (71) on the Console as
shown. Attach the Handrail with three 3/4”
Screws (2). Make sure that the console wire is
not pinched. Start all three Screws before
t
ightening any of them. Do not overtighten
t
he Screws.
Attach the other Handrail (not shown) to the
other side of the Console (43) as described
above.
With the help of a second person, raise the
Uprights (not shown) to the vertical position.
71
43
Console Wire
5
2
2
2
6. Remove the plastic tie securing the Wire
Harness (42) to the right Upright (69). Next, in-
sert the colored tie on the Wire Harness up
through the large holes in the right Handrail (71)
as shown. Then, pull the Wire Harness up
through the holes.
Set the Handrails (71) and the Console (43) on
the Uprights (69).
Make sure that the Wire
Harness (42) and the console wire are not
pinched. Discard the colored wire.
Next, connect the Wire Harness (42) to the con-
sole wire. Make sure to connect the connec-
tors properly (see the inset drawing). The
connectors should slide together easily and
snap into place. If they do not, turn one connec-
tor and try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Then, insert the con-
nectors and excess wire into the Console (43).
69
42
43
6
95
37
71
Console
Wire
Colored Tie
42
Console
Wire