Filter
Top Products
8
7. Tighten the four Handrail Bolts (37) with the four
1/4” Star Washers (95) into the Uprights (69) and
the Handrails (71).
Start all four Bolts before
tightening any of them.
95
37
95
37
71
71
95
69
69
37
7
5. Set the Console (43) face down on a soft surface
to avoid scratching the Console. Next, set one of
t
he Handrails (71) on the Console as shown.
Attach the Handrail with three 3/4” Screws (2).
Make sure that the console wire is not
pinched. Start all three Screws before tight-
e
ning any of them. Do not overtighten the
S
crews.
Then, attach the other Handrail (not shown) to
the other side of the Console (43) as described
above.
With the help of a second person, raise the
Uprights (not shown) to the vertical position.
71
43
Console Wire
5
2
2
2
6. Remove the plastic tie holding the Wire Harness
(42) to the right Upright (69). Insert the colored
tie on the Wire Harness up through the large
holes in the right Handrail (71) as shown. Pull
the Wire Harness up through the holes.
Next, set the Handrails (71) with the Console
(43) onto the tops of the Uprights (69).
Make
sure that the Wire Harness (42) and the con-
sole wire are not pinched. Untie and discard
the colored wire.
Then, connect the Wire Harness (42) to the con-
sole wire. Make sure to connect the connec-
tors properly (see the inset drawing). The
connectors should slide together easily and
snap into place. If the connectors do not slide
together easily and snap into place, turn one
connector and try again. IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Insert the connectors
and excess wire into the Console (43).
69
42
43
6
42
95
37
71
Console
Wire
Colored Tie
Console
Wire