ProForm 831.295050 Treadmill User Manual


 
If you purchase the optional chest pulse sensor (see
page 20), follow the steps below to install the receiver
included
with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated Screw (108) and the Access Door (96).
2.
Remove the paper from the adhesive pad on the back of
the receiver (A). Orient the receiver so the small cylin
-
der is near the lower edge of the receiver and is fac-
ing the Console (107) as shown.
Firmly press the re
-
ceiver onto the indicated corner of the Access Door (96).
Connect the wire on the receiver to the indicated wire ex-
tending from the Console.
3. Make sure that no wires are pinched. Reattach the
Access Door (96) with the Screw (108). Note: The wires
included with the receiver may be discarded.
8. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 23). To protect the floor or carpet, place a mat under the treadmill.
80
84
6. If you wish to adjust the height of the Uprights (80,
84), go to step 7. If the Uprights are at the desired
height,
tighten the four Upright Bolts (86) and go to step 8.
7. Note: The Uprights (80, 84) can be attached at three dif-
ferent heights. The Uprights are preattached in the mid-
dle position. Adjusting the Uprights requires two persons.
While a second person holds the Console Base (101) and
the Uprights (80, 84), loosen the four Upright Bolts (86).
Then, remove the two Upright Bolts and Upright Star
Washers (45) from the Right Upright (80). Raise or lower
the Right Upright to the desired height, being careful not
to damage the Wire Harness (74). If the Upright Spacer
(79) falls, press it back onto the Upright Base (97).
Loosely thread the two Upright Bolts and Upright Star
Washers back into the Right Upright and the Upright Base.
Adjust the Left Upright (84) in the same way. (Note:
There are no wires in the Left Upright.)
Make sure that
both Uprights are at the same height. Lift the Walking
Platform (13) and make sure that it is centered be-
tween the Uprights. Then, retighten all four Upright
Bolts (86).
79
101
86
13
45
86
45
74
80
84
97
97
86
86
7
A
107
96
Cylinder
108
7
79
97
6
Wire
Wire