Filter
Top Products
3. Hold the Right Handrail (94) at an angle as shown and
insert the upper end into the Right Upright (11). Keep
the lower end of the Handrail away from the treadmill
to avoid scratching the finish. Next, rotate the lower
end of the Handrail to the position shown by the dotted
line.
Make sure that the hole in the lower end of the Right
Handrail (94) is aligned with the hole in the Extension
Leg (34). If the holes are not aligned, rotate the Handrail
away from the treadmill and pull the upper end of the
Handrail out of the Upright (11) slightly. Then, rotate the
Handrail back to the position shown by the dotted line.
Repeat until the holes are aligned.
5. Attach the Storage Latch (14) to the left Upright (11) with
two Latch Screws (35). Be careful not to overtighten
the Latch Screws.
4. Attach the Right Handrail (94) to the Extension Leg (34)
with a Handrail Bolt (93), a Handrail Washer (92) and a
Handrail Nut (91).
Repeat steps 3 and 4 to attach the Left Handrail (not
shown).
11
34
34
92
93
91
94
4
35
14
11
5
88
6
6. Remove the backing from the Adhesive Clip (33). Press
the Adhesive Clip onto the right Upright (11) in the indi-
cated location. Press the Allen Wrench (88) into the
Adhesive Clip.
11
33
7. Make sure that all parts are tightened before you use
the treadmill. To protect the floor or carpet, place a mat
under the treadmill.
94
3
6