Filter
Top Products
9
Follow the steps below to operate the console.
Insert the key into the power switch.
Inserting the key will
not turn on the dis-
plays. The displays will
turn on when the
ON/RESET button is
pressed or when the
walking belt is started.
Note: If you just
installed batteries, the displays will already be on.
Reset the speed control.
Slide the speed control
down to the RESET
position. Note: Each
time the walking belt
is stopped, the speed
control must be
moved to the RESET
position before the
walking belt can be
restarted.
Start the walking belt.
After you have moved the speed control to the
RESET position, slowly slide it upward until the
walking belt begins to move at slow speed.
Carefully step onto the walking belt and begin ex-
ercising. Change the speed of the walking belt as
desired by sliding the speed control.
To stop the walking belt, step onto the foot rails
and slide the speed control to the RESET position.
During the first few minutes that you use the tread-
mill, inspect the alignment of the walking belt, and
align the walking belt if necessary (see page 13).
Adjust the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
top or bottom of the in-
cline control until the
desired incline level is
reached.
Monitor your progress with the two displays.
TIME/DISTANCE dis-
play—This display
shows the elapsed time
and the distance that
you have walked or
run, in miles. Every
seven seconds, the dis-
play will change from one number to the other, as
shown by the arrows in the display.
CALS/FAT CALS/
SPEED display—This
display shows the ap-
proximate numbers of
calories and fat calories
you have burned. (See
FAT BURNING on
page 14.) In addition, the display shows the speed
of the walking belt, in miles per hour. Every seven
seconds, the display will change from one number
to the next, as shown by the arrows in the display.
To reset the displays at
any time, press the
ON/RESET button.
When you are finished exercising, stop the
walking belt and remove the key.
Step onto the foot rails, slide the speed control to
the RESET position, and remove the key from the
console. The displays will turn off about five min-
utes after the key is removed. Note: Any time that
the walking belt is stopped and the ON/RESET
button is not pressed for five minutes, the dis-
plays will automatically turn off in order to con-
serve the batteries.
6
5
4
3
2
1
Arrow
Arrow