Filter
Top Products
7
5. With the help of another person, carefully raise the
Uprights (35, 58) to the vertical position, with the wheels
and the walking platform on the floor as shown on page 5.
Have the other person hold a Handgrip Post (41) on the
Left Upright (35) as shown. Hold a Post Spacer (43) in-
side of the Handgrip Post. Insert a Post Bolt (44) with a
1/4” Washer (107) through the end hole in the Handgrip
Post and through the Post Spacer. Finger tighten the
Post Bolt. Finger tighten another Post Bolt (44) with a 1/4”
Washer (107) into the other hole. If necessary, tap the
Handgrip Post with a rubber mallet to make sure that it is
fully seated. Tighten the Post Bolt in the end hole.
Then, tighten the other Post Bolt.
Attach the other Handgrip Post (41) to the right Upright
(not shown) as described above.
5
107
107
End
Hole
43
44
41
35
4. Locate the Belly Pan Wire Harness (124). Route the Belly
Pan Wire Harness over the Base (117) as shown.
Connect the Belly Pan Wire Harness to the Wire Harness
(55). See the bottom inset drawing. The connectors
should slide together easily and “snap” into place. If
the connectors do not slide easily and snap into place,
turn a connector and try again. See the top inset drawing.
Carefully wrap the wires around the connectors as
shown. Insert the connectors and the excess Wire
Harness into the Right Upright (58).
With the help of another person, carefully tip the treadmill
onto its other side. Attach the Left Upright, the other Base
Leg, the left Front Wheel, and the other Base Pads (not
shown) as described in steps 1 through 3. (Note: There is
not a wire harness in the Left Upright.) Do not fully
tighten the bolts yet.
4
55
124
117
6
6. Have another person hold the Console Base (52) near
the Uprights (35, 58). Locate the wire harness extending
from the Console Base. Connect the wire harness to the
Wire Harness (55) in the Right Upright. The connectors
should slide together easily and “snap” into place. If
the connectors do not slide easily and snap into place,
turn a connector and try again. Carefully feed the connec-
tors and the excess wire harness into the Right Upright.
Carefully set the Console Base on the posts on the
Uprights.
Finger tighten four Console Bolts (42) with four Star
Washers (113) into the Uprights (35, 58) and the Console
Base (52). After all four Console Bolts have been started,
tighten them.
See steps 1 and 2. Tighten the two Upright Bolts (66).
Next, tighten the four Base Leg Bolts (77). Make sure
that the Base Leg Nuts (70) are fully seated in the
square holes. Note: It may be helpful to tip the tread-
mill onto its side while you do this.
113
113
42
42
58
35
52
55
Wire Harness
58