Filter
Top Products
8
46
96
Ties
47
5
5. Place the Console Base (46) on the Right Handrail (47)
and the Left Handrail (not shown). Attach the Console
Base with four 3/4” Screws (13) (only two Screws are
shown).
Do not tighten the Screws yet.
Insert the Wire Harness (21) through the two indicated
plastic ties on the Console Base (46). Next, insert the
Wire Harness up through the opening beside the Console
Cover (96). Make sure that the Console Cover is securely
attached to the Console Base.
See the inset drawing. Look at the top of the Console
Base (46). Insert the Wire Harness (21) through the plas-
tic tie on top of the Console Base.
21
21
Tie
46
13
46
10
21
6. Hold the Console (10) near the Console Base (46).
Touch the Right Handrail (47) to discharge any static.
See the inset drawing. Find the 3-wire connector on the
end of the Wire Harness (21). Insert the connector into
the red socket beneath the console. The connector
should slide easily into the socket and snap into
place. If the connector does not slide easily and snap
into place, turn the connector and then insert it. Insert the
5-wire connector into the black socket beneath the con-
sole in the same way.
Insert the excess Wire Harness (21) down through the
opening in the Console Base (46 [see the inset drawing
in step 5]). Securely tighten the plastic tie on top of
the Console Base to prevent the Wire Harness from
slipping. Then, cut off the end of the plastic tie.
Make sure that the connectors and wires appear as
shown at the right. IF THE CONNECTORS ARE NOT
INSERTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED ON.
See drawing 6a. Press the Book Rack (90) onto the
Console Base (46) in the location shown.
Set the Console (10) on the Console Base (46). Insert
the excess Wire Harness (21) into the large hole in the
side of the Right Handrail (47).
Securely tighten the
plastic ties on the bottom of the Console Base to
prevent the Wire Harness from slipping. Then, cut off
the ends of the plastic ties.
Attach the Console (10) to the Console Base (46) with four
3/4” Screws (13) and two 1/2” Silver Screws (97).
Start all
six Screws before tightening them; do not over-
tighten the Screws.
6
13
13
97
47
Ties
46
90
6a
5-wire
3-wire
21