Filter
Top Products
512
68
1
3
1
1. Loosen the Lock Knob (68) on the right side of the
Frame (1). Slide the Seat Frame (3) out until it
stops. Tighten the Lock Knob.
2. Attach the Upright (2) to the Frame (1) with three
M10 x 25mm Button Head Screws (25) and three
M10 Split Washers (26). Be careful not to pinch
the Reed Switch Wire (13) or the Resistance
Cable (10).
3. Route both Extension Wires (41) up through the
Upright (2) as shown.
Attach the Handlebar (4) to the Upright (2) with two
M6 x 25mm Hex Head Screws (14) and two M6 Split
Washers (67), but do not tighten the Screws yet.
Make sure that the Screws are threaded into the
indicated holes. Note: Two additional Screws will
be attached in step 5.
2
2
26
26
25
25
25
1
10
13
3
41
2
14
14
67
67
4
Inspect and tighten all parts of the PROFORM
¨
975s
regularly. The 975s can be cleaned with a soft, damp
cloth. To prevent damage to the console, keep liquids
away and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced. To replace the batteries, refer to
assembly step 11 on page 7.
CRANK ADJUSTMENT
If the arms of the
Crank (14)
become loose,
they should be
tightened in
order to prevent
excessive wear.
Loosen the
Crank Nut (35)
on the left arm of
the Crank. Place
the end of a
standard screw-
driver in one of the slots in the Slotted Bearing Nut
(33). Lightly tap the screwdriver with a hammer to turn
the Slotted Bearing Nut counterclockwise until the
arms are no longer loose. Do not overtighten the
Slotted Bearing Nut. When the Slotted Bearing Nut
is properly tightened, tighten the Crank Nut.
HOW TO STORE THE PROFORM
¨
975S
When the PRO-
FORM
¨
975s is
not in use, it can
be folded for
compact storage.
Refer to the
drawing at the
right. Loosen the
Lock Knob (68)
on the right side
of the Frame (1).
Slide the Seat
Frame (3) as far
into the Frame
as it will go. Tighten the Lock Knob. Store the PRO-
FORM
¨
975s indoors, away from moisture and dust.
MAINTENANCE AND STORAGE
35
33
14
68
3
1
4. Connect the Reed Switch Wire (13) and the two
Extension Wires (41) to the corresponding wires on
the Console (8).
Attach the ground wire to the Upright (2) with an M4
x 16mm Screw (75).
Attach the Console (8) to the Upright (2) with four #8
x 5/8Ó Screws (22).
Press the Resistance Knob (9) onto the Resistance
Control (10). Be sure that the mark on the Knob is
correctly aligned.
Console
Wires
Ground
Wire
10
8
9
13
75
2
41
22
22
4