Filter
Top Products
8
2b
B
116
PULSE
Jack
If you purchase the optional chest pulse sensor (see
page 19), follow the steps below to install the receiver in-
cluded with the chest pulse sensor.
1. Make sure that the power plug is unplugged. Remove
the six or seven indicated Screws (46) from the back of
the Console Base (116).
2. Connect the Short Jumper Wire (A) to the wire on the
Receiver (B). Connect the other end of the Short Jumper
Wire to the PULSE jack on the back of the Console (see
drawing 2b). Next, peel the paper off the pad on the back
of the Receiver. Turn the Receiver so that the cylinder
is on the side shown, and press the Receiver into the
bottom of the Console Base (116) in the indicated loca-
tion. Note: A Long Jumper Wire is included but will not be
used.
Make sure that no wires are pinched. Reattach the
back of the Console Base (116) with the Screws (46) (see
step 1 above).
116
46
1
A
2a