Filter
Top Products
4. With the help of a second person, carefully raise
the Uprights (84) to a vertical position.
Have the second person hold the Handrail (20)
near the Uprights (84). Insert the Upright Wire
Harness (77)
into the hole in the bottom of the
Handrail and out of the top as shown.
Next, set the Handrail (20) on the Uprights (84).
Do not let the Upright Wire Harness (77) fall
into the right Upright.
Attach the Handrail (20) with four Handrail Bolts
(64) and four Star Washers (8); start all four
Handrail Bolts and then firmly tighten them.
See steps 1 and 2. Fully tighten the two Front
Endcap Screws (14).
7
84
20
8
8
77
64
84
64
2. With the help of a second person, carefully tip
the treadmill onto its right side. Do not fully fold
t
he treadmill until it is completely assembled.
I
nsert the other Extension Leg (89) into the base
of the Uprights (84). Hold an Extension Leg
Nut (67) in the bottom of the Extension Leg, and
thread a 2.25" Extension Leg Bolt (92) with a
Star Washer (8) into the top of the Extension
Leg. Next, thread a 2.5" Extension Leg Bolt (65)
with a Star Washer (8) into the bottom of the
Extension leg. Firmly tighten the Extension
Leg Bolts.
Slide the other Front Endcap (44) onto the base
of the Upright (84). Partially tighten a Front
Endcap Screw (14) into the Front Endcap and
the base.
89
65
44
84
14
8
8
92
67
2
3. Attach two Base Pads (82) to the base of the
Uprights (84) with two 1" Tek Screws (83).
84
83
83
82
82
3
4